Flooring and cladding in the bill of quantities
5 categories and 14 items
What the division covers
This division covers ceramic and porcelain tiling to floors and walls, marble and granite to floors, stairs and vanity tops, facade cladding in natural stone and glass-fibre reinforced concrete, resilient, wood and raised floors, screeds and terrazzo tiles. In building projects in Saudi Arabia it follows plastering, waterproofing and testing of services, and precedes the final coat of paint, doors and sanitary ware. Its materials are high in value and vary widely in price by type, size and source, so the estimator concentrates on the approved material, the waste from cutting and tile size, and the bedding, adhesive and screed beneath the tile.
Where it weighs most
This division weighs most in villas, palaces, residential towers, hotels, shopping centres and mosques, with their wide marble and porcelain floors and clad facades; it appears in hospitals and schools as vinyl and terrazzo floors, and in office buildings and data centres as raised floors and carpet.
Ceramic and porcelain tiles
Ceramic and porcelain are pressed ceramic tiles for floors and walls. Porcelain has very low water absorption and higher hardness, so it is chosen for floors, external areas and heavy traffic, while lighter glazed ceramic is chosen for bathroom and kitchen walls. Tiles are fixed either in traditional cement mortar over a sand bed, or with cementitious adhesive on a screed or true plaster; adhesive is preferred for large formats and low-absorption porcelain. Tile size, rectified edges and grout type determine the level of waste and labour.
Marble and granite
Marble and granite are natural stones cut into slabs and tiles to clad floors, stairs, walls and countertops. Marble is softer and richer in veining but sensitive to acids, so it is chosen for halls, entrances and walls; granite is harder and less absorbent, so it is chosen for stairs, kitchen tops and heavy-traffic areas. Prices vary widely by type, quarry, selection grade and thickness; common floor thickness is 2 to 3 cm. It is fixed in cement mortar or adhesive and polished on site after laying.
Facade cladding
Facade cladding is an outer skin fixed to the frame and walls to protect them and give the building its final appearance. The best-known material in the Kingdom is natural stone such as Riyadh limestone, marble and granite, fixed either by mortar bedding with metal ties for limited heights, or by dry mechanical fixing on stainless steel angles and anchors with an air cavity for taller buildings. Glass-fibre reinforced concrete elements are used for cornices, columns, screens and ornamental panels because they are light and easy to mould.
Resilient and wood flooring
This category gathers floors that are glued or assembled on a finished level base: vinyl in sheets, tiles and planks for hospitals, schools and shops because it is easy to clean; solid or engineered wood parquet for bedrooms and offices; carpet in rolls or tiles for offices, hotels and mosques for comfort and sound absorption; and raised floors on pedestals for computer rooms and offices with services running beneath. What they share is complete dependence on a flat, dry screed, since any defect beneath shows on the surface.
Screeds and terrazzo
A screed is a cement–sand layer laid over the structural slab to set levels, cover services and form falls before the final finish; it is laid bonded to the slab or separated from it over insulation, usually 4 to 7 cm thick. Terrazzo tiles are pressed cement tiles with a face of marble chips and cement, ground after laying and chosen for schools, mosques, corridors and roofs for their durability, low cost and easy maintenance. Both rely on local cement and sand and on labour for levelling and curing.
Other divisions
Price your whole bill of quantities
Upload the bill of quantities and its items are priced from published references, each with its price source.
Start nowجرّب بلا تسجيل