Screeds and terrazzo in the bill of quantities
A screed is a cement–sand layer laid over the structural slab to set levels, cover services and form falls before the final finish; it is laid bonded to the slab or separated from it over insulation, usually 4 to 7 cm thick. Terrazzo tiles are pressed cement tiles with a face of marble chips and cement, ground after laying and chosen for schools, mosques, corridors and roofs for their durability, low cost and easy maintenance. Both rely on local cement and sand and on labour for levelling and curing.
Where it sits in the bill and what comes before it on site
Screeds come before tiling items in the flooring section, and terrazzo is listed with them or with tiling. Beforehand the floor services must be finished and tested, any waterproofing and thermal insulation laid, and finished levels marked on the walls.
Items in this category
| Item | Unit |
|---|---|
| Floor screed | m² (or m³ for screeds to falls) |
| Terrazzo tiles | m² |
What is often left out when pricing it
- Light mesh or fibres in a floating screed over insulation to prevent cracking.
- Control joints and the perimeter isolation strip at walls and columns in large areas.
- Curing with water or covering for several days, and protecting the screed from early traffic.
- Grinding, polishing and grouting terrazzo on site after laying, which is separate labour and plant.
Frequently asked questions
Is screed measured in square metres or cubic metres?
It is commonly measured in square metres with the average thickness stated in the item description, and sometimes in cubic metres for screeds laid to falls of varying thickness on roofs. If the actual thickness greatly exceeds that stated because of slab level differences, the contractor seeks a rate adjustment or measurement by volume.
How does pricing differ between a bonded and a floating screed?
A bonded screed is laid directly on a cleaned, dampened slab with a cement slurry and is thinner. A floating screed is laid over thermal, acoustic or waterproofing layers, so it needs greater thickness, mesh or fibres and a perimeter strip. Mortar and sundries per square metre are therefore higher for the floating type.
Is grinding included in the rate for terrazzo tiles?
It is where the item description calls for grinding and polishing, which is usual for internal floors. Roof and pavement tiles usually come with a factory-ground or rough face and are not ground on site. The contractor checks the wording, because grinding needs plant, water, slurry disposal and several passes with graded stones.
Related calculators and terms
Other categories in Flooring and cladding
Price your whole bill of quantities
Upload the bill of quantities and its items are priced from published references, each with its price source.
Start nowجرّب بلا تسجيل