Marble flooring in the bill of quantities
| Unit | m² |
|---|---|
| Category | Marble and granite |
| Division | Flooring and cladding |
The item as worded in the bill
Supply and lay natural marble flooring of the approved type, 2 cm thick, sized as the layout drawing, first selection uniform in colour and veining, bedded in white cement and clean sand mortar over a sand bed, with tight joints filled with grout tinted to match the marble, including grinding and polishing on site in stages to the required gloss.
Method of measurement
Measured in square metres of net area laid between finished wall faces, deducting columns and unlaid areas and adding door thresholds executed in the same marble. Borders and bands in a different marble and water-jet-cut patterns are measured under separate items in linear metres, square metres or by number. Cutting and selection waste is not measured, and grinding and polishing are in the rate unless stated otherwise.
What the unit rate covers
- Marble slabs of the approved thickness and selection
- White cement mortar or adhesive as described
- Site cutting and vein matching as the layout
- Grouting in the colour of the marble
- Grinding and polishing on site
- Protection until handover
Priced separately
- Borders and patterns in a different marble
- Skirtings and worked door thresholds
- Screed or fill beneath the floor
- Stain-protection sealer where a separate item exists
Specification and reference
Marble slabs comply with ASTM C503 for physical properties and are approved against samples showing the acceptable range of colour and veining. The specification fixes thickness, finish and bedding type, with white cement used under light-coloured stones. The work falls under the Saudi general building code SBC 201, and slip resistance is considered at entrances and areas liable to wetting.
What moves the rate
- Marble type, quarry and selection grade
- Thickness and slab size
- Complexity of the layout, borders and patterns
- Required level of grinding and polish
Common pricing mistakes
- Adopting a supply price without fixing the selection grade, then having the engineer reject slabs of uneven colour and demand a higher selection.
- Omitting site grinding and polishing, a multi-stage operation with machines, abrasive stones and polishing materials separate from laying.
- Calculating marble waste at the rate for ceramic tiles, although cutting to layout, vein matching and rejecting defective slabs raise it.
- Using ordinary grey cement in the bedding under light marble, so dark stains appear from behind and slabs have to be replaced.
Related calculators and terms
More items in Marble and granite
Price your whole bill of quantities
Upload the bill of quantities and its items are priced from published references, each with its price source.
Start nowجرّب بلا تسجيل