Cable trays in the bill of quantities
| Unit | lin. m |
|---|---|
| Category | Cables and containment |
| Division | Electrical works |
The item as worded in the bill
Supply and install hot-dip galvanised steel cable trays, perforated type, 300 mm wide with 50 mm side height and 1.5 mm thickness; the rate includes bends, tees, reducers, splice plates and their bolts, supports and hangers of angles and threaded rods at about 1.5 m centres, earth bonding links between sections, and the cover where required.
Method of measurement
Measured in linear metres along the tray centre line, each width and type (perforated, ladder, wire mesh) separately, bends and tees included at their length with no extra unless the bill gives a numbered item for special fittings. Vertical runs in shafts are measured like horizontal ones. Covers are measured with the tray where described, otherwise per linear metre under a separate item. Supports and hangers are not measured separately.
What the unit rate covers
- Tray of the specified width, thickness and finish
- Bends, tees, reducers and splice plates
- Hangers, brackets, bolts and anchors
- Earth bonding links between sections
- Touching up cut edges with zinc-rich paint
Priced separately
- Cables and their cleats
- Fire-stopping at penetrations
- Earth conductor run along the tray
Specification and reference
Installed to SBC 401 and the project specification as regards electrical continuity, earthing, fill ratio and segregation of power from low-current cables. Trays are supplied to IEC 61537 with a load capacity suited to the cable weight and support spacing, hot-dip galvanised after fabrication for outdoor and damp locations and pre-galvanised for dry indoor locations.
What moves the rate
- Width and sheet thickness
- Type of galvanising or stainless steel
- Perforated, ladder or mesh, with or without cover
- Hanging height and congestion of services
Common pricing mistakes
- Pricing the straight metre only, when special fittings such as bends, tees and reducers cost several times their own length.
- Forgetting hangers, threaded rods and anchors; their close spacing makes them a large part of the cost per metre.
- Pricing pre-galvanised trays for the roof or open car parks where the specification requires hot-dip galvanising after fabrication.
- No coordination with air-conditioning ducts and fire pipes, so the tray is refixed on a longer route with bends that were not priced.
Related calculators and terms
More items in Cables and containment
Price your whole bill of quantities
Upload the bill of quantities and its items are priced from published references, each with its price source.
Start nowجرّب بلا تسجيل