Internal plaster in the bill of quantities
| Unit | m² |
|---|---|
| Category | Plastering |
| Division | Plaster, paint and gypsum works |
The item as worded in the bill
Supply and apply internal cement plaster to walls and soffits, not less than 15 mm thick in two coats over a cement spatterdash, in Portland cement and clean sand mortar, including level dots and screeds, mesh at concrete-to-block junctions, metal corner beads at angles and water curing; the rate includes scaffolding and everything necessary to complete the work to specification.
Method of measurement
Measured in square metres of net area executed. Door and window openings are deducted, and their plastered reveals and sills are added. Height is taken from structural floor level to the soffit, or to the stated distance above a suspended ceiling. Mesh, beads and spatterdash are not measured separately unless given their own item, and nothing is added for waste.
What the unit rate covers
- Spatterdash, undercoat and finishing coat
- Level dots and screeds, and control of line and plumb
- Mesh at junctions of dissimilar materials and over service chases
- Metal beads at external angles
- Internal scaffolding and water curing
Priced separately
- Rough backing coat under wall tiles where a separate item exists
- Filler and paint
- Making good after later alterations by other trades
Specification and reference
Plaster is governed by the gypsum board and plaster provisions of the Saudi general building code SBC 201 and by the project specification. Cement complies with ASTM C150, sand is clean, graded and free of salts and clay, and cement plaster is applied in line with ASTM C926 as regards number of coats, thicknesses and curing.
What moves the rate
- Actual thickness needed to correct uneven blockwork
- Storey height and the need for taller scaffolding
- Proportion of soffits and beams to walls
- Small rooms with many angles and openings
Common pricing mistakes
- Taking plaster height as the full floor-to-floor height without deducting the slab thickness, which inflates the quantity on every storey.
- Pricing on 15 mm thickness when uneven blockwork demands a greater actual thickness, so mortar consumption exceeds the calculation.
- Forgetting the soffits of stair flights and landings and the sides of downstand beams, areas that do not appear in a room-by-room take-off.
- Allowing full smooth plaster behind kitchen cabinets and bathroom tiling where only a rough backing coat is required.
A published price for its main material
The monthly Kingdom-wide average as published by the General Authority for Statistics, with its monthly series: Black National Cement
Related calculators and terms
More items in Plastering
Price your whole bill of quantities
Upload the bill of quantities and its items are priced from published references, each with its price source.
Start nowجرّب بلا تسجيل