Cement board partitions in the bill of quantities
| Unit | m² |
|---|---|
| Category | Drywall partitions |
| Division | Plaster, paint and gypsum works |
The item as worded in the bill
Supply and install partitions of 12 mm fibre-reinforced cement boards on a frame of galvanised steel studs and tracks at 400 mm centres, fixed with corrosion-resistant screws, with joints treated with alkali-resistant mesh tape and cement-based compound, mineral wool infill where required, and the surface prepared to receive tiles or paint as the finishes schedule.
Method of measurement
Measured in square metres of partition area on one face, by centre-line length and height built, deducting door openings. Where one face is cement board and the other gypsum board, the item says so and it is measured as a separate type. Lining an existing wall with cement board on framing to one side is measured under a lining item, not the partition item. Waterproofing and tiling are excluded.
What the unit rate covers
- Galvanised framing at the specified spacing
- Cement boards and corrosion-resistant screws
- Mesh tape and cement-based compound to joints
- Cutting boards around pipes and boxes
- Backing at fixing points for sanitary fittings
Priced separately
- Waterproofing to wet areas
- Tiling or final painting
- Steel carrier frames for wall-hung toilets
Specification and reference
The specification fixes the board type and thickness; flat fibre-cement sheets comply with ASTM C1186 and framing members with ASTM C645. Fixing and joint treatment follow the manufacturer’s instructions, particularly screw spacing and movement joints. The work falls under the Saudi general building code SBC 201, and in wet areas a waterproofing membrane over the board is required before tiling.
What moves the rate
- Board thickness, weight and difficulty of cutting
- Stud spacing and steel gauge
- Number of pipe penetrations in bathrooms
- Cement board to one face or to both
Common pricing mistakes
- Pricing it at gypsum board productivity, although cement board is heavier, is cut by saw and needs two men to lift and fix.
- Calculating studs at 600 mm centres as in standard partitions while the specification requires closer spacing under tiling, understating the framing.
- Using ordinary screws and gypsum compound in the analysis instead of the corrosion-resistant screws and cement-based compound this board requires.
- Assuming cement board removes the need for waterproofing in showers, so the membrane is dropped from pricing and later demanded by the engineer.
Related calculators and terms
More items in Drywall partitions
Price your whole bill of quantities
Upload the bill of quantities and its items are priced from published references, each with its price source.
Start nowجرّب بلا تسجيل