Prefabricated water storage tanks in the bill of quantities
| Unit | No. (or m³ of capacity for sectional tanks) |
|---|---|
| Category | Tanks and pumps |
| Division | Plumbing and drainage |
The item as worded in the bill
Supply and install a prefabricated roof water tank in insulated multi-layer polyethylene, suitable for potable water and UV-resistant, 2000 litres capacity, with a tight-fitting lid and a screened vent; the rate includes hoisting to the roof, seating on a level base, inlet, outlet, overflow and drain connections, the float valve, and disinfection before commissioning.
Method of measurement
One-piece manufactured tanks are measured by number for each capacity and type. Tanks assembled from glass-fibre panels are measured by number with dimensions and nominal capacity stated, or per cubic metre of capacity, including panels, internal stays, the base frame, ladder and manhole. The capacity taken is the nominal one in the description, not the effective capacity after deducting the freeboard. The concrete base is measured under its own item.
What the unit rate covers
- Tank of the specified capacity and material with lid
- Hoisting and placing in position
- Inlet, outlet, overflow and drain nozzles
- Float valve and wash-out valve
- Ladder and level indicator for sectional tanks
- Disinfection and fill test
Priced separately
- Concrete base or supporting steel frame
- Pipework to and from the tank
- Shade structure or screen wall for the tanks
Specification and reference
SBC 701 requires potable water tanks to have a tight cover, an insect-proof overflow and vent, and a material that does not affect water quality. The project specification calls for a certificate of suitability for contact with drinking water and resistance to UV and summer heat, and the full tank’s load on the slab is checked under SBC 301.
What moves the rate
- Capacity, number of layers and thermal insulation
- One piece or panels assembled on site
- Building height and means of hoisting
- Vertical or horizontal, and the roof area available
Common pricing mistakes
- Overlooking the crane cost to get the tank onto a high roof, or that its size will not pass through the roof stair.
- Placing the tank on a slab not designed for it; the weight when full is one tonne per cubic metre of water.
- Pricing a single-layer tank where a multi-layer insulated one is described; water overheats in summer and the tank is rejected at handover.
- Forgetting the fully flat base under the tank bottom; point bearing cracks the bottom and voids the warranty.
Related calculators and terms
More items in Tanks and pumps
Price your whole bill of quantities
Upload the bill of quantities and its items are priced from published references, each with its price source.
Start nowجرّب بلا تسجيل