PEX water supply pipes in the bill of quantities
| Unit | lin. m (or per point) |
|---|---|
| Category | Water supply network |
| Division | Plumbing and drainage |
The item as worded in the bill
Supply and install cross-linked polyethylene (PEX) supply pipes, 16 mm diameter, inside a protective corrugated sleeve, run in one length without joints from the distribution manifold to the fixture outlet; the rate includes the sleeve, the brass wall elbow and its box, manifold connectors, fixing and pressure testing, but excludes the manifold and its cabinet, which are measured separately.
Method of measurement
Measured in linear metres of the actual route from the manifold to each outlet; every outlet has its own line, so distances cannot be added along a shared main as in branched networks. The length includes the rise from the manifold, the drop to the floor and the rise to the outlet. The sleeve is not measured separately. Where measurement is per point, cold and hot outlets are counted separately.
What the unit rate covers
- PEX pipe of the specified diameter
- Corrugated sleeve colour-coded for cold and hot
- Wall elbow and fixing box at the outlet
- Press or compression connectors at the manifold
- Pressure test before screed and tiling
Priced separately
- Distribution manifolds with their cabinets and valves
- The main line feeding the manifold
- Screed cover over pipes laid on the slab
Specification and reference
Executed to SBC 701, with pipes manufactured to ISO 15875 or equivalent and certified for potable water. The line between manifold and outlet must be one piece inside a sleeve that allows the pipe to be withdrawn and replaced, connectors and manifolds must belong to the same manufacturer’s system, and the minimum bending radius in the manufacturer’s data is respected.
What moves the rate
- Distance of the manifold from the fixtures and number of outlets
- Connector type: tool-pressed or hand-tightened compression
- An oxygen barrier or aluminium layer in the pipe
- Pipe diameter and wall thickness
Common pricing mistakes
- Calculating length as for a branched network, whereas every outlet takes a full line from the manifold, so the metres multiply.
- Forgetting the manifold, its cabinet and valves when they have no item, leaving a cost with no line in the bill.
- Pricing an unsleeved pipe where the specification requires the sleeve, or the reverse; the difference in material and labour is marked.
- Overlooking that the pressing tool and connectors are system-specific, so one manufacturer’s pipes cannot be mixed with another’s connectors.
Related calculators and terms
More items in Water supply network
Price your whole bill of quantities
Upload the bill of quantities and its items are priced from published references, each with its price source.
Start nowجرّب بلا تسجيل