Polypropylene (PPR) water supply pipes in the bill of quantities
| Unit | lin. m (or per point in small projects) |
|---|---|
| Category | Water supply network |
| Division | Plumbing and drainage |
The item as worded in the bill
Supply and install polypropylene (PPR) water supply pipes, nominal pressure PN20, 25 mm diameter, jointed by heat fusion; the rate includes all elbows, tees, reducers and other fittings shown on the drawings, fixing with clips, cutting wall chases and making good, pressure testing and disinfection, and everything needed to complete the work to the specification and the engineer’s instructions.
Method of measurement
Measured in linear metres along the pipe centre line, each diameter separately, without deducting fittings and valves and with no allowance for wastage or for pipe ends inside the fusion sockets. Horizontal lengths come from the drawings; risers and drops to fixtures are added from the levels, not by guess. Where the item is per point, only outlets are counted and the bathroom pipework is carried in the point rate.
What the unit rate covers
- Pipes of the specified diameter and pressure rating
- Fused fittings and brass-threaded fittings at fixture outlets
- Clips, supports and sleeves at penetrations
- Cutting chases in walls and making good
- Pressure testing, disinfection and flushing
Priced separately
- Main valves, pressure-reducing valves and meters
- Thermal insulation of hot water pipes
- Excavation and backfilling for lines buried outside the building
Specification and reference
The network is governed by the Saudi Building Code SBC 701 for plumbing; pipes and fittings are made to DIN 8077 and DIN 8078 from random copolymer polypropylene suitable for potable water. The pressure rating suits the operating temperature, pipes and fittings come from one source, and fusion follows the temperature and time stated by the manufacturer.
What moves the rate
- Diameter and pressure rating (PN)
- Density of fittings per metre, higher inside bathrooms
- Chased into walls or exposed on hangers
- A fibre or aluminium composite layer for hot water lines
Common pricing mistakes
- Pricing the metre on pipe cost alone, although the elbows and tees of a single bathroom may cost as much as its pipes or more.
- Using the lower-rated cold water pipe on the hot line to save the difference, which the engineer then rejects at material inspection.
- Ignoring thermal expansion of long exposed hot water runs, so expansion loops and sliding supports are left out of the rate.
- Taking lengths off the plan only and forgetting the drops to fixtures inside the walls and the risers between floors.
Related calculators and terms
More items in Water supply network
Price your whole bill of quantities
Upload the bill of quantities and its items are priced from published references, each with its price source.
Start nowجرّب بلا تسجيل