Rainwater drainage in the bill of quantities
| Unit | lin. m for downpipes, No. for roof outlets |
|---|---|
| Category | Sewage disposal and rainwater |
| Division | Plumbing and drainage |
The item as worded in the bill
Supply and install uPVC rainwater downpipes, 110 mm (4 inch) diameter, from the roof outlet to the discharge point at ground level; the rate includes the roof outlet with domed leaf guard and membrane clamping collar, bends and fittings, galvanised clamps for fixing to the facade or inside the shaft, the bottom discharge shoe, and a flow test.
Method of measurement
Downpipes are measured in linear metres from the roof outlet spigot to the discharge point, including any horizontal run below the roof slab, each diameter separately. Roof outlets and parapet scuppers are counted by number. Grated ground drainage channels are measured in linear metres including body and grating. Buried lines to the street or soakaway well are measured with buried pipes, and soakaway wells by number.
What the unit rate covers
- Downpipes and their fittings
- Galvanised fixing clamps
- Roof outlet with domed grating where described
- Discharge shoe or connection to the ground line
- Water flow test
Priced separately
- Roof waterproofing and screed to falls
- Buried lines and soakaway wells
- Boxing-in exposed downpipes with cladding or gypsum
Specification and reference
Rainwater disposal is governed by SBC 701, which sizes downpipes and outlets from roof area and design rainfall intensity, requires secondary emergency drainage for roofs enclosed by parapets, and prohibits connecting rainwater to the foul drainage network. Roof falls and ponding loads are considered structurally under SBC 301, and exposed pipes are sunlight-resistant.
What moves the rate
- Building height and number of downpipes
- Exposed on the facade or within shafts or columns
- Pipe material and roof outlet type
- Final discharge: street, storm network or well
Common pricing mistakes
- Counting the main roof outlets only and forgetting annex roofs, the stair room roof, canopies and open balconies.
- Measuring the downpipe by storey heights only and missing the horizontal run below the slab, the parapet and the bottom length to the discharge point.
- Ignoring the means of access for fixing exposed downpipes on the facade, especially if installed after the finishing scaffold is struck.
- Pricing an ordinary floor drain for the roof; a roof outlet differs in its domed grating, membrane clamping collar and larger capacity.
Related calculators and terms
More items in Sewage disposal and rainwater
Price your whole bill of quantities
Upload the bill of quantities and its items are priced from published references, each with its price source.
Start nowجرّب بلا تسجيل