Thermal insulation in the bill of quantities
Thermal insulation reduces heat transfer through the building envelope and is mandatory for new buildings in Saudi Arabia under the energy conservation code. On roofs, extruded polystyrene boards are laid over the waterproof membrane in an inverted roof, or sprayed polyurethane foam is used, bonding directly to the surface and following its irregularities. On walls, insulated block, insulation boards between two leaves, or an external system bonded and covered with reinforced render are used, with columns and beams insulated too. The building’s thermal calculation sets each material’s thickness.
Where it sits in the bill and what comes before it on site
Thermal insulation items appear in the insulation section. They are executed on roofs after the waterproofing passes its test, and on walls after masonry is complete and before plaster or cladding. Before delivery, the engineer must approve the material and its thermal properties certificate.
Items in this category
| Item | Unit |
|---|---|
| Roof thermal insulation with polystyrene boards | m² |
| Thermal insulation to external walls | m² |
| Sprayed polyurethane foam insulation | m² |
What is often left out when pricing it
- The separation layer of geotextile or polyethylene sheeting over the insulation boards.
- Insulating the faces of external columns and beams and window reveals to break thermal bridges.
- The protective coating against sunlight over polyurethane foam left exposed on the roof.
- Mechanical fixings, fibre mesh and corner beads in the external wall insulation system.
Frequently asked questions
How do I check that the thickness in the bill is sufficient?
Thickness is the designer’s responsibility and results from the building’s thermal calculation under the energy conservation code. The contractor prices the thickness, type and density given, and notifies in writing any conflict between the bill and the specification or drawings, since a lower-performing substitute is rejected by the engineer even at equal thickness.
What is the difference between extruded and expanded polystyrene in pricing?
Extruded polystyrene has higher compressive strength and lower water absorption, so it suits an inverted roof over the membrane and under tiles, and costs more. Expanded is cheaper and used where it meets neither water nor load, as inside walls. Where the specification names one, do not price the other; they differ beyond thickness.
Does sprayed foam replace waterproofing?
Closed-cell foam resists water penetration and, with its protective coating, is treated as combined thermal and water insulation on many villa roofs. Many project specifications nevertheless require a separate waterproof membrane under or over it. The specification wording governs; do not drop the waterproofing item from your pricing because a foam item exists.
Related calculators and terms
Other categories in Waterproofing and thermal insulation
Price your whole bill of quantities
Upload the bill of quantities and its items are priced from published references, each with its price source.
Start nowجرّب بلا تسجيل