Privacy screens in the bill of quantities
| Unit | m² (or lin. m with height stated) |
|---|---|
| Category | Shades and screens |
| Division | Metal and steel works |
The item as worded in the bill
Supply and install privacy screen 2 m high on top of an existing boundary wall, of 80×80 mm square hollow-section posts 2 mm thick every 2.5 m fixed to the wall columns with base plates and chemical anchors, 40×40 mm horizontal rails, clad with 0.5 mm pre-painted corrugated sheet, including primer, two finishing coats and all fixing accessories.
Method of measurement
Measured by square metre, the length along the wall centreline multiplied by the exposed height of the screen above the wall top, or by linear metre with the height stated. The post length running down beside the wall for fixing and sheet overlaps are not measured. Corner returns are measured at their actual length, gate openings are deducted, and each stepped part is measured at its own height.
What the unit rate covers
- Posts and horizontal rails
- Cladding sheets, fabric or slats
- Base plates and chemical anchors
- Painting
- Cutting and installation
- Post end caps
Priced separately
- Strengthening or repairing the existing wall
- New concrete columns for the wall
- Municipality permit procedures
Specification and reference
Wind load on a solid screen is the governing load, so the frame and its fixings are designed to SBC 301 and SBC 306, and the capacity of the existing wall to take the additional forces is verified. Municipality requirements set the maximum height of screens above walls and the permitted materials, and are checked before fabrication.
What moves the rate
- Screen height
- Cladding type: corrugated sheet, fabric, laser-cut or slats
- Post spacing and size
- Condition of the existing wall and fixing method
Common pricing mistakes
- Treating a solid screen as an open fence, although the wind force on it is high and posts and anchors must be designed, not guessed.
- Fixing into hollow block between the wall columns, where anchors do not hold, so the concrete columns must be reached.
- Measuring the length at one height and forgetting the stepping of the wall top, which changes the exposed height from part to part.
- Overlooking the finish of the face towards the neighbour, where the municipality may require both faces to look acceptable.
Related calculators and terms
More items in Shades and screens
Price your whole bill of quantities
Upload the bill of quantities and its items are priced from published references, each with its price source.
Start nowجرّب بلا تسجيل