Play and sports surfaces in the bill of quantities
Play and sports surfaces are resilient surfaces that protect children and players from the effect of falls. Poured-in-place rubber surfacing consists of a base layer of black rubber granules and a coloured top layer; it is laid without joints in free shapes and colours and is chosen for play areas in parks and schools. Ready-made rubber tiles are quicker to lay and easier to replace, and suit small areas and exercise rooms. Either way, thickness is set by the critical fall height of the equipment installed above.
Where it sits in the bill and what comes before it on site
They appear in the external works section after the paving items or with the playground equipment. The concrete or asphalt base must be complete, laid to falls and dry, and equipment footings and surrounding kerbs must be fixed before pouring.
Items in this category
| Item | Unit |
|---|---|
| Rubber play surfacing | m² |
What is often left out when pricing it
- The base under the rubber surfacing, in concrete, asphalt or compacted aggregate, usually carried in another item.
- Extra thickness in the fall zone around high equipment compared with the rest of the play area.
- Bonding primer on the base, and chamfered finishing edges at kerbs and manhole covers.
- Multi-colour graphics and shapes, which raise labour and waste above a single colour.
Frequently asked questions
How is the thickness of rubber surfacing determined?
From the critical fall height of the highest point a child can fall from on each piece of equipment, using the manufacturer’s tables based on impact attenuation testing. Thickness may vary within one play area, so each thickness zone is taken off as a separate item or area.
Is rubber surfacing measured over the gross area or after deducting equipment footings?
It is measured in square metres of the area actually laid. Planting beds, islands and uncovered areas are deducted; small equipment posts that the surfacing is laid around are not. Trimming around posts is extra labour carried in the unit rate, not in the quantity.
How do poured-in-place surfacing and tiles differ in price?
Poured surfacing depends on specialist labour, binders and suitable weather and gives a continuous surface; tiles depend on the supply price and speed of laying, with visible joints. Compare them at the same thickness and the same impact attenuation level, not on the bare rate per square metre.
Related calculators and terms
Other categories in External works and roads
Price your whole bill of quantities
Upload the bill of quantities and its items are priced from published references, each with its price source.
Start nowجرّب بلا تسجيل