Painting in the bill of quantities
Painting covers coating internal walls and ceilings with water-based emulsion, coating elevations with smooth or textured acrylic systems, and oil and epoxy paints for special surfaces and floors. A system consists of a primer, filler and finishing coats whose number and type are fixed by the finishes schedule. Matt emulsion is chosen for dry rooms, washable semi-gloss for corridors and kitchens, acrylic systems resistant to sunlight and heat for elevations, and epoxy where resistance to abrasion and chemicals and ease of cleaning are required.
Where it sits in the bill and what comes before it on site
Painting items follow plastering and suspended ceilings in the bill of quantities, and their final coats are applied near the end of the project. The plaster must be fully dry, concealed electrical and air-conditioning work finished, and floors and aluminium protected before starting.
Items in this category
| Item | Unit |
|---|---|
| Internal emulsion paint | m² |
| External textured coating | m² |
| Epoxy floor coating | m² (or lin. m for coved skirtings) |
What is often left out when pricing it
- Protection of floors, windows and switch plates with sheeting and tape, and removal of splashes on completion.
- The final touch-up coat after doors and fixtures are installed, making good damage caused by other trades.
- The extra filler needed on uneven surfaces or fair-faced concrete compared with well-finished plaster.
- Mobile towers needed for high ceilings, stairwells and double-height lobbies.
Frequently asked questions
Is filler included in the rate per square metre of paint?
Usually yes: the internal paint item in Saudi contracts is described as a complete system of primer, two filler coats and finishing coats. Check the item wording and the required finish level, because full sanded filler over the whole surface takes far more labour than local filling of defects only.
How is the paint area taken off from the drawings?
Start from the net plastered area of walls and soffits, then deduct areas covered with ceramic, marble or panelling and unpainted suspended ceilings. Add painted gypsum board ceilings and the reveals of openings. Each paint type is measured separately according to the room finishes schedule.
Does the rate for painting ceilings differ from walls?
The actual cost differs: overhead work is slower and needs a platform, and ceilings show filler defects under raking light. If the bill gives one item for walls and ceilings, price it on a weighted average; if it separates them, the ceiling rate per square metre should stand above the wall rate.
Related calculators and terms
Other categories in Plaster, paint and gypsum works
Price your whole bill of quantities
Upload the bill of quantities and its items are priced from published references, each with its price source.
Start nowجرّب بلا تسجيل