Concrete block in the bill of quantities
Hollow concrete block is the most common walling material in framed buildings in Saudi Arabia, made of cement and aggregate with a 40×20 cm face in thicknesses of 10, 15 and 20 cm. The 20 cm size serves external, stair and light-well walls, 15 cm or 10 cm internal partitions, and solid block walls that touch soil or carry concentrated loads. It is laid in cement–sand mortar and tied to the concrete columns, and the type is chosen by the wall’s position, function, and fire-resistance and insulation requirements.
Where it sits in the bill and what comes before it on site
Block items appear in the bill of quantities directly after the concrete works, split by thickness and type. Before starting, the floor’s formwork must be struck, wall lines set out on the slab, and the block sample and its compressive strength test results approved.
Items in this category
| Item | Unit |
|---|---|
| 200 mm hollow concrete blockwork | m² |
| 150 mm blockwork for internal partitions | m² |
| Solid blockwork below ground level | m² (or m³) |
What is often left out when pricing it
- Ties between the wall and the concrete columns, and the mesh or bar reinforcement laid in the bed joints.
- Filling the gap between the top course and the beam or slab soffit with a suitable material.
- Internal and external scaffolding and hoisting of blocks and mortar to the upper floors by crane or hoist.
- Wastage from cutting blocks at openings and corners and from breakage in handling and transport.
Frequently asked questions
Are door and window openings deducted from the blockwork area?
Blockwork is normally measured net, with openings deducted, but the method of measurement written in the preambles governs: some contracts do not deduct small openings below a stated limit, and some include lintels in the block rate. Read the preambles before taking off and do not assume the method from a previous project.
How many blocks go into one square metre?
A block with a 40×20 cm face and a mortar joint of about 1 cm gives roughly 12.5 blocks per square metre whatever the wall thickness. Cutting and breakage wastage is added on top, and it is higher in short walls with many openings and corners than in long plain walls.
Are wall reinforcement and ties included in the block rate or priced separately?
In most Saudi bills of quantities the rate per square metre carries column ties and bed-joint reinforcement unless a separate item is given, whereas concrete stiffeners and lintels are usually measured in their own items. If the bill is silent on them, raise a query before bidding or allow for them explicitly in your rate.
Related calculators and terms
Other categories in Masonry works
Price your whole bill of quantities
Upload the bill of quantities and its items are priced from published references, each with its price source.
Start nowجرّب بلا تسجيل