Lintels and wall stiffeners in the bill of quantities
Lintels are reinforced concrete members that carry the wall above door and window openings in blockwork, cast in place or precast. Stiffener columns and beams are small concrete members of the wall’s width cast within it to stabilise long or high walls, free ends, the sides of wide openings and parapets. Precast lintels are chosen when opening sizes repeat and speed is wanted; casting in place suits wide or non-standard openings. The positions of stiffeners are set by the general notes of the structural drawings.
Where it sits in the bill and what comes before it on site
These items appear in the bill under masonry works or at the end of concrete works. They are built with the wall, so stiffener starter bars must first be fixed in the slabs and final opening sizes known from the door and window drawings.
Items in this category
| Item | Unit |
|---|---|
| Concrete lintels over openings | lin. m (or m³) |
| Stiffener columns and beams for walls | lin. m (or m³) |
What is often left out when pricing it
- Lintels over openings for air-conditioning ducts, electrical panels and fire hose cabinets in internal and external walls.
- Drilling and fixing dowels with epoxy in hardened concrete when they were not left in before casting.
- Formwork to small stiffeners, which takes far more labour than their concrete volume suggests.
- Placing these members by hand in small scattered quantities that do not suit a concrete pump.
Frequently asked questions
Are lintels measured by the linear metre or by the cubic metre?
Both methods are used. The linear metre, with the cross-section stated, is clearer for repetitive lintels; the cubic metre is common when they are grouped with stiffener concrete. Either way the length is the opening width plus the bearing at both ends, and rates usually include reinforcement and formwork unless the bill states otherwise.
Stiffeners are not drawn on the plans; how do I take them off?
Go back to the general notes and typical details in the structural drawings, which set the maximum wall length and height without stiffening. Then go through the architectural plans wall by wall and apply the rule: a column at each free end and at the stated spacing, and a beam where height exceeds the limit.
Is the area of lintels and stiffeners deducted from the blockwork area?
It depends on the preambles’ method of measurement. Strict measurement deducts them because they replace blockwork, but many bills leave small members undeducted for simplicity. What matters is not to carry the area twice in your analysis, as block and as concrete, and to know which method the engineer will apply in payment certificates.
Related calculators and terms
Other categories in Masonry works
Price your whole bill of quantities
Upload the bill of quantities and its items are priced from published references, each with its price source.
Start nowجرّب بلا تسجيل